Defenderworx H2 BUMPER LETTERS Instrukcja Użytkownika Pobierz pdf

BUMPER LETTER INSERT

INSTALLATION INSTRUCTIONS

Use an alcohol pad to clean the surface of the letters and plastic bumper where the tape will be

applied. Make sure all surfaces are smooth and dry before applying letters. Apply 3M Adhesion

promoter to the surface of the bumper where the letters will be applied. Allow surface to dry for 5

minutes. Remove the plastic film from the back of the letter you will be applying and then apply

letter to bumper and press firmly. Do not wash or allow the bumper to get wet for at least 48

hours.

NOTE; Do not allow the 3M Adhesion Promoter to get on any surface other than where the

letters will be placed.

Defenderworx, Inc.

1120 North Armando Avenue

Anaheim, CA 92806

(714) 630-9700 Phone

(714) 630-9701 FAX

www.defenderworx.com

BUMPER LETTER INSERT INSTALLATION INSTRUCTIONS Use an alcohol pad to clean the surface of the letters and plastic bumper where the tape will be app

Brak uwag

Defenderworx H2 BUMPER LETTERS Instrukcja Użytkownika